Hydrex offer a wide range of underwater repair or maintenance work on ship thruster units.
An entire unit can be overhauled, propeller blades or seals can be replaced or repair work on a specific part of a thruster can be performed fast by Hydrex diver/technicians on site. All of these repairs can be carried out without the need to drydock the vessel.
Hydrex was the first company to show that it was possible to remove and then replace thrusters fast by creating a dry environment underwater. Using the Hydrex-developed steel mobdocks to seal off the thruster tunnel, with an access shaft protruding above the water, work teams accessed the thruster tunnel and removed or repaired the thruster within the tunnel in complete safety. This was done in conditions similar to those above water.
Hydrex has since then developed this technology further using lightweight flexible mobdocks. These modernized mobdocks, which are designed to be easily transported around the world, are used to close off the thruster tunnel on both sides. This allows divers to work in a dry environment around the unit.
The company has also developed a permanent thruster repair and replacement system for offshore related vessels and units. This system has been developed so it can be tailored to most vessels. It can be included in the planning for a newbuild, installed on a unit going to drydock or constructed and brought onboard at any other suitable time. With such a system on standby any repair work to the thruster that may arise can be dealt with much faster and more easily.
There is no need to send the vessel to drydock as all operations can be carried out in port or while the vessel is stationary at sea. Normal commercial activities can therefore continue without disruption.
